Free Keystone Pattern: Baby Hat!

One thing about me is that I love a quick project. Especially when that project is a present for my BFF's brand new nephew! Last week, my friend let me know her sister just had a baby, and I knew I had to cast on a project for him...however nothing on Ravelry spoke to me. 

I've recently been in love with garter ribbing, it's so stretchy and the garter ridges add a nice little detail. So I thought, hey, I've got two amazing professional pattern designers at my disposal... why don't I just cast on a garter rib hat and see where the wind takes me? I know Kate and Courtney have my back if something goes awry.

Without further ado, here's the pattern for the adorable Baby Hat I created!

Yarn:
Kelbourne Woolens Keystone, 1 skein

Gauge:
18 sts and 28 rnds = 4" (10 cm) on larger needles, after blocking. 
Needles:
1 - 16" US 7 (4.5 mm) circular
1 - 16" US 8 (5 mm) circular
1 set - US 8 (5 mm) DPNs 
Size:
14.25" Brim circumference, 7" height

Directions

Hem:
Using smaller circular needles, CO 64 sts. 

Place stitch marker at BOR, join for working in the round, being careful not to twist sts.

Ribbing:
Rnd 1: *K2, p2; repeat from * around.
Rnd 2: K all sts

Repeat rnds 1-2 until garter rib reaches 1.5" or desired length.

Body:
Change to larger ndls.

Work in St st until piece meas 3 1/2" from CO edge, or desired length.

Decrease for Crown:
Rnd 1 (Set-Up): *K 16, pm; rep from * around.

Rnd 2 (Dec): *K2tog, k until 2 sts before m, ssk, sl m; rep from * around - 8 sts dec'd.
Rnd 3: K all sts

Rep prev 2 rnds 6 times more - 8 sts.

Finishing:
Break yarn, leaving an 8” (20 cm) tail. Thread through live sts and fasten off. Soak pieces in cool water and Soak wash and block to measurements. Weave in ends.
Shop This Post
1
Shop This Post
1

1 comment

Thank you for the free baby hat pattern; it’s adorable!!

Jo Langer

Leave a comment

Please note, comments need to be approved before they are published.